Radio Shack ET-2105 Bedienungsanleitung

1CONTENTSFeatures ... 1Selecting a Location ...

9• If the CHARGE/IN USE indicator does not light when youplace the keypad on the base, be sure the battery pack andAC adapter are correctly and secure

10Cautions: • Be careful not to short the battery pack by touching it withconducting materials, such as rings, bracelets, and keys. Thebattery pack or

11Note: If your phone system requires that you dial an accesscode (9, for example) before you dial an outside number, donot press the access code eith

12per side of the clip into the slots on both sides of the keypad. Toremove the belt clip, pull out on either side of the clip. OPERATIONBefore you us

13Adjusting the Keypad’s VolumeTo adjust the keypad’s volume level (4 levels), repeatedly pressVOLUME 9999 or 8888 during a call until the sound level

14Using MuteTo talk to someone else in the room without the person on the oth-er end of the phone line hearing your conversation, press MUTE.Press MUT

15Using PageYou can send a page to the keypad to locate it when it is awayfrom the base and not in use. To page the keypad, press PAGE/FIND on the bas

164. Press the memory location number (1–0) you want to store.The keypad sounds two long beeps.Note: If you hear three short beeps, you did not store

17Dialing a Stored NumberPress TALK. When you hear the dial tone, press MEM then thememory location number (1–0). The phone dials the number.Chain Dia

18TROUBLESHOOTINGWe do not expect you to have any problem with your telephone,but if you do, these suggestions might help.Problem SuggestionThe keypad

© 2001 RadioShack Corporation.All Rights Reserved.RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.OWNER’S MANUAL — Please

19If you still have problems, disconnect the phone. If other phoneson the same line work properly, the fault is in this phone or its in-stallation. If

RadioShack CorporationFort Worth, Texas 7610243-2105086-002138-01605A01Printed in ChinaLimited One-Year WarrantyThis product is warranted by RadioShac

2Page — lets you send a paging signal from the base to the key-pad to help locate a misplaced keypad or page someone at thekeypad.Detachable Belt Clip

3READ THIS BEFORE INSTALLATIONWe have designed your phone to conform to federal regulations,and you can connect it to most telephone lines. However, e

4Important:• Cordless phones such as this one require AC power to oper-ate. When the AC power is off, you cannot dial out or receiveincoming calls usi

5Also, the phone company can make changes to its lines, equip-ment, operations, or procedures that could affect the operation ofthis telephone. The te

6• Use outlets on different electrical circuits for the equipmentand the radio or TV.Consult your local RadioShack store if the problem still exists.P

7date the wiring for you. You must use compatible modular jacksthat are compliant with Part 68 of FCC Rules.Note: The USOC number of the jack to be in

85. Lift the base’s antenna to a vertical position.Connecting, Charging, and Replacing the Battery PackThe phone comes with a rechargeable NiMH batter