Radio Shack Easy Remote Spezifikationen PDF herunterladen (Seite 4)

The backlight lets you see the keys on your 6-in-1 in the dark. Press

(Symbol) to light the keys. Also, every time you press a key, the 6-in-1

lights up and stays lit for about 5 seconds.

To turn off the light, press (Symbol) again.

SETTING UP YOUR REMOTE CONTROL:

1. Refer to "Manufacturer's Codes" on Faxback Doc. #36485 and write down

the codes for your original remote controls.

Note:

Some manufacturers have several possible codes listed. Try each until

you find the correct code. See "Operation" on Faxback Doc. # 38051 if

you need help.

2. Press the device key for the type of remote you are replacing (CD,

VCR, CBL, TV, AUX 1 or AUX 2).

3. Press and hold SET UP until the red indicator light blinks twice, then

release it. Enter the 3-digit code.

For example, to replace a TV's remote control (manufacturer's setup code

154), press:

TV - SET UP 1 - 5 - 4

4. When the red indicator light blinks twice again, the 6-in-1 has

accepted the code.

5. Point the 6-in-1 Remote Control at your device and press PWR (or CH/ON

for some cable boxes). Your device should turn off (or on, if it was

off).

If the remote does not operate your device, try the other codes listed in

the "Manufacturer's Codes" for your brand of TV, VCR, cable converter, or

other devices.

Repeat Steps 2-5 for additional devices.

Note:

The punch-through feature (see "Operation" on Faxback Doc. #38051) is

automatically turned on for the TV's volume and mute controls. This

means that when you select cable, for example, and press one of the

volume keys or the mute key, the remote actually sends that function to

the television, not the cable converter. If you want to use your cable

converter's volume and mute controls, disable the punch-through feature

for these keys.

1 2 3 4 5 6 7 8 9 ... 45 46

Keine Kommentare

Radio Shack Easy Remote Spezifikationen Seite 4