AM/FM Cassette Car Stereo w/22 Watts x 2 Max Power (120-2130A) Features Faxback Doc. # 60662 Your RadioShack AM/FM
to its owner's manual. Connecting a Compact Disc Player You can connect a portable CD player (or other audio component with a line-leve
AM/FM Cassette Car Stereo w/22 Watts x 2 Max Power (120-2130A) Operation Faxback Doc. # 60664 Using The Controls Wh
Note: If the stereo is already on and you have the display set to the radio frequency, press F/C (frequency/clock). The clock display
Note: If the stereo does not find a strong station when seeking or scanning, the stereo searches the band
2. Use any tuning method to tune to the station you want to store. 3. Hold down the desired memory location button (1-6) until the memory loca
press AMS. The radio begins scanning the stored stations - AM1 and AM2, or FM1, FM2 and FM3. Note: Do not hold down AMS. This causes the radio to a
forward through the entire cassette in both directions. Fast-Forward and Rewind To rewind or quickly fast-forward the current side, firmly pr
AM/FM Cassette Car Stereo w/22 Watts x 2 Max Power (120-2130A) Care and Maintenance Faxback Doc. # 60665 Your RadioShack AM/FM
Clean the tape head after about every 20 hours of playing time. Insert a special head-cleaning cassette, and follow the cassette's direction to
3. Push the fuse holder ends together and twist one end clockwise. 4. Reconnect the cable to the vehicle battery's negative (-) terminal.
Automatic Seek and Scan - adjusts your stereo so the first time it Sensitivity searches a band it stops only on strong local
AM/FM Cassette Car Stereo w/22 Watts x 2 Max Power (120-2130A) Specifications Faxback Doc. # 60666 Radio:
Specifications are typical; individual units might vary. Specifications are subject to change and improvement without notice. (BR EB 7/28/00) LN-03
AM/FM Cassette Car Stereo w/22 Watts x 2 Max Power (120-2130A) Installation Faxback Doc. # 60663 Preparation CAUTION:
1. Loosen each shaft nut about halfway up the shaft. 2. Move each shaft positioner to the correct pair of holes. 3. Hold each shaft positioner i
the 14-pin connector into the stereo. If any wire connections are made incorrectly or out of order, damage to the stereo is
1. Connect the black GROUND (-) wire to a chassis ground, such as a metal screw attached to a metal part of the vehicle's frame. Be sure
(Green) + (Violet) + (Green/Black) - (Violet/Black) - 1. Use a small screwdriver to move (2 ch)
or it might not be marked at all. 4. Connect the white FRONT LEFT (+) wire to the left speaker's positive terminal. 5. Connect the
3. Position the stereo in the dashboard as follows: a. Place one supplied nut and washer on each shaft and tighten the nuts about halfwa
Kommentare zu diesen Handbüchern